Auto Exposure Bracketing (AEB)

In exposure bracketing, three consecutive images are captured at different exposures within your specified range of up to ±3 stops (in 1/3-stop increments) by automatically adjusting the shutter speed, aperture value, or ISO speed.

AEB stands for Auto Exposure Bracketing.

Select [: Expo.comp./AEB].
Set the AEB range.
- Turn the dial to set the AEB range (1). By using the keys, you can set the amount of exposure compensation.
- Press the button to set it.
- Once an AEB range is set, it is shown on the screen on the exposure level indicator.
Take the picture.

Standard exposure

Decreased exposure

Increased exposure
- Three bracketed shots are taken, according to the specified drive mode, in this sequence: Standard exposure, decreased exposure, and increased exposure.
- AEB will not be automatically canceled. To cancel AEB, follow step 2 to turn off the AEB range display.

Caution

Exposure compensation in AEB may be less effective with [: Auto Lighting Optimizer] () set to an option other than [Disable].

Note

If the drive mode is set to [], press the shutter button three times for each shot. In [], [], or [] mode, holding down the shutter button completely captures three images, one after another, before the camera automatically stops shooting. When [] or [] is set, three consecutive shots are captured after a delay of 10 or 2 sec. When set to [], three times the specified number of shots are taken in continuous shooting.
You can set AEB in combination with exposure compensation.
AEB is not available in flash photography or bulb exposures, in HDR mode, or with Multi Shot Noise Reduction, focus bracketing, or shooting creative filters.
AEB is canceled automatically after the power switch is set to and after the flash is fully charged.