Inserting/Removing the Battery and Card

Insert a fully charged Battery Pack LP-E17 and card in the camera. The captured images are recorded onto the card.

Insertion

  1. Slide the card/battery compartment cover lock and open the cover.

  2. Insert the battery.

    • Insert the end with the electrical contacts.
    • Insert the battery until it locks in place.
  3. Insert the card.

    • Insert the card with the label facing the front of the camera until it clicks into place.

    Caution

    • Make sure the card's write-protect switch (1) is set upward to enable writing and erasing.
  4. Close the cover.

    • Press the cover closed, then slide the card/battery compartment cover lock to lock it.

Caution

  • You cannot use batteries other than the Battery Pack LP-E17.

Formatting the Card

If the card is new or was previously formatted (initialized) by another camera or computer, format the card with this camera ().

Removal

  1. Slide the card/battery compartment cover lock and open the cover.

    • Set the power switch to Power off.
    • Make sure the access lamp (1) is off before opening the card/battery compartment cover.
    • If [Saving...] is displayed on the screen, close the cover.
  2. Removing the battery.

    • Press the battery lock lever as shown by the arrow and remove the battery.
    • To prevent short-circuits, always attach the included protective cover () to the battery.
  3. Remove the card.

    • Gently push in the card, then let it go to eject.
    • Pull the card straight out, then close the cover.

Caution

Do not remove cards immediately after a red [Overheating restriction (red)] icon is displayed as you are shooting. Cards may be hot, due to high internal camera temperature. Set the power switch to Power off and stop shooting for a while before removing cards. Removing hot cards immediately after shooting may cause you to drop and damage them. Be careful when removing cards.

Note

  • The number of shots available varies depending on remaining card capacity and settings such as image quality and ISO speed.
  • Setting [Shooting: Release shutter without card] to [Disable] will prevent you from forgetting to insert a card ().

Caution

  • When the access lamp is lit or blinking, it indicates that images are being written to, read from, or erased from the card, or data is being transferred. Do not open the card/battery compartment cover. To avoid corrupting image data or damaging cards or the camera, never do any of the following while the access lamp is lit or blinking.

    • Removing the card.
    • Removing the battery.
    • Shaking or striking the camera.
    • Unplugging or plugging in a power cord
      (when using optional household power outlet accessories).

  • If the card already contains recorded images, the image number may not start from 0001 ().
  • If a card-related error message is displayed on the screen, remove and reinsert the card. If the error persists, use a different card.

    If you can transfer images on the card to a computer, transfer all the images and then format the card with the camera (). The card may then return to normal.

  • Do not touch the card's contacts with your fingers or metal objects. Do not expose the contacts to dust or water. If smudges adhere to the contacts, contact failure may result.
  • Multimedia cards (MMC) cannot be used. (Card error will be displayed.)