Automatic Flash Photography with Receivers divided into 2 Groups

You can adjust the lighting balance (flash ratio) with receivers separated into 2 groups, A and B.

The total (sum) of light from firing groups A and B is automatically controlled to a achieve standard exposure.

  1. Push the joystick vertically.

    • Control the receivers and set each one.

  2. Set the receiver firing group to (1).

    • Select either A or B for the firing group.
    • Set 1 receiver to A and the other to B.

  3. Set the sender firing group (2).

    • Operate the sender to set steps 3-5.
    • Push the joystick up / down / left / right or turn Select dial to select an item, and push the joystick vertically.

  4. Set to A:B.

    • Press the joystick to the left or right, turn Select dial to select A:B to select, then push the joystick vertically.

  5. Set the A:B flash ratio.

    • Push the joystick vertically to select an item in the figure.
    • Push the joystick to the left or right or turn Select dial to set the amount of compensation, and push the joystick vertically.

  6. Take the picture.

    • The receiver will fire at the set flash ratio.
  • previous
  • next