Wireless Multiple Flash Shooting with a set Flash Ratio

This section describes wireless multiple flash shooting using manual flash. You can set the flash output in 1/3-stop increments for shooting in the range from full flash (1/1) to 1/128 flash for each firing group. Set all the parameters on the sender unit.

  1. Select MODE with the joystick.

  2. Set the flash mode to M.

    • Press the joystick up, down, left, or right, or turn Select dial and select M, then press the joystick vertically.

  3. Push the joystick vertically.

  4. Select an item in (1).

    • Push the joystick up / down / left / right or turn Select dial to select an item, and push the joystick vertically.

  5. Set the firing group.

    • Push the joystick to the left or right or turn Select dial to select the flash method from the following. You can use wireless multiple flash shooting with firing groups A, B, and C added.

      • All receiver units have the same flash output:ALL
      • Setting the flash ratio for firing groups A and B:A:B
      • Setting the flash ratio for firing groups A, B, and C:A:B:C

  6. Select a firing group.

    • If you selected A:B or A:B:C in Step 2, push the joystick vertically and then push the joystick up and down, or turn Select dial to select the group to set the flash output.

  7. Set the flash output.

    • Push the joystick vertically.
    • Push the joystick to the left or right or turn Select dial to set the flash output, then push the joystick vertically.
    • Repeat Step 3 and 4 to set the flash output of all the groups.

  8. Take the picture.

    • Each group fires at the set flash output.

Note

  • When set to ALL, the firing group setting of the receiver unit can be either A, B, or C. All the groups fire at the set flash output.