Test Flash / Modeling Flash from a Receiver Unit

During radio transmission wireless shooting, test flash and modeling flash () can be performed from the EL-1 set as the receiver unit.

  1. Push the joystick vertically.

  2. Fire the flash.

    [Test flash firing]

    • Press the joystick up, down, left, or right, or turn Select dial and select TEST, then press the joystick vertically.

    [Modeling flash] ()

    • Press the joystick up, down, left, or right, or turn Select dial and select MODEL, then press the joystick vertically.
    • A flash signal is sent from the receiver unit to the sender unit, and a wireless system test flash or modeling flash is fired.

Caution

  • Modeling flash is not possible from a receiver unit with cameras released up to 2011 or with EOS REBEL T100/4000D/3000D, EOS REBEL T7/1500D/2000D, EOS REBEL T6/1300D or EOS REBEL T5/1200D.
  • For the precautions related to modeling flash, see "Modeling Flash".
  • When C.Fn-02-1 is set on the sender unit (), modeling flash will not be fired even if you select MODEL.

Note

  • If there are two or more sender units (), the flash signal is sent to the main sender.