Sending Images to a Web Service

This section describes how to send images to

Registering and Setting Up Auto Send

You can register on the camera and prepare to send your shots automatically.

  • A computer or smartphone with a browser and internet connection is required.
  • You will need to enter an email address used on your computer or smartphone.
  • For instructions on how to use services and details on countries and regions where it is available, visit the site (
  • Separate ISP connection and access point fees may apply.

Steps on the camera (1)

  1. Set Wi-Fi settings to [Enable].

  2. Select [Wireless features: Wi-Fi/Bluetooth connection].

  3. Select [Web service Upload to Web service].

  4. Select [I Agree].

  5. Establish a Wi-Fi connection.

  6. Enter your email address.

    • Enter your email address, then select [OK].
  7. Enter a four-digit number.

    • Enter a four-digit number of your choice, then select [OK].
  8. Select [OK].

    • The [Web service] icon changes to [Update Web service].

Steps on the computer or smartphone

  1. Set up camera web link.

    • Access the page in the notification message.
    • Follow the instructions to complete the settings on the camera web link settings page.

Steps on the camera (2)

  1. Select [OK].

    • The [Update Web service] icon changes to [Auto send].
  2. Select [Upload to Web service].

  3. Select [Auto send].

    • Once [Enable] is set, images are automatically sent when you turn the camera on.
  4. Select [Type to send].

    • Set to [Stills only] or [Stills+movies].
  5. Restart the camera.

    • The images are now sent automatically.
  • To switch networks, select [Switch network] and follow steps 5–8.
  • To remove the connection, select [Clear camera web link settings] and then [OK].


  • All image files on cards are sent when [Auto send] is set to [Enable].
  • When [Auto send] is set to [Enable], auto send starts after the camera starts up (or recovers from auto power off).
  • Any images captured during auto sending are also sent.


  • Auto send does not start during interval timer shooting.
  • Transfer stops in the following cases.

    • [Airplane mode] is set to [On]
    • Movie recording is started
    • A USB connection is started
    • Battery capacity is low
    • The camera's power switch is set to Power off