Basic Linked Shooting

Link the sender camera and the receiver cameras for basic linked shooting.

Preparing the Sender Camera

First, configure settings on the camera that will be used as the sender.

  1. Press the MENU button on the camera.

  2. Select [Wireless settings: WFT settings].

  3. Select [Enable].

  4. Select [Connection settings].

  5. Select [LinkedShot].

    • Use Quick Control Dial and select [LinkedShot] located at the bottom.
  6. Select [Create with wizard].

    • Select [OK] to proceed to the next screen.
  7. Select [Sender].

    • Select [OK] to proceed to the next screen.
  8. Select [Auto connect].

    • Select [OK] to proceed to the next screen.
    • Stay on the displayed screen.
    • Up to nine compatible receiver cameras can be linked when you select [Manual connect].

Preparing the Receiver Cameras

Configure settings on the camera used as the receiver.

  1. Follow steps 1–6 in Preparing the Sender Camera.

  2. Select [Receiver].

    • Select [OK] to proceed to the next screen.
  3. Select [OK].

    • The following screen is displayed.

    • To use more than one receiver camera, repeat Step 2 and 3 for all the receiver cameras.
    • Once setup is complete, no more receiver cameras can be added. You need to configure the settings again starting from Step 1.
    • The number of receiver cameras detected is displayed on the sender camera screen.

Connecting the Sender Camera and Receiver Cameras

Configure settings on the sender camera and the receiver camera to establish a connection.

  1. Follow steps 1–6 in “Preparing the Sender Camera” and steps 1–3 in “Preparing Receiver Cameras.”

  2. Select [OK] on the sender camera.

    • Check the number of receiver cameras that are connected, and then select [OK].
    • Once the cameras are connected, the following screen is displayed.
  3. Select [OK] on all the cameras.

    Sender Camera

    Receiver Camera

    • The [Network settings] screen will reappear.
    • Settings information is stored in the camera. It is not stored in the transmitter.