Introduction

  • Before Using This Transmitter, Be Sure to Read the Following

    • To comply with local radio wave regulations, Canon offers five region-specific versions of the transmitter (A, B, C, D, and E) in various areas around the world (see separate sheet). For convenience, the transmitter in this guide is referred to as WFT-R10, without reference to versions A, B, C, D, or E.
    • In this guide, the term “access point” refers to devices such as wireless LAN access points or wireless LAN routers that relay a LAN connection.
    • These instructions should be followed only after setting up your LAN and FTP server environments. For information about setting up the environments, refer to the documentation provided with each device or contact the manufacturer.
    • Read the Camera's Advanced User Guide and familiarize yourself with operating the camera before following the instructions on camera options.
    • This transmitter cannot be directly connected to a telecommunication carrier's communication line. When connecting this transmitter to the internet, make sure to connect it through a router.
  • Support

    Image transfer requires adequate knowledge of configuring your LAN and FTP server. Canon cannot provide support for configuring LANs or FTP servers.

  • Liability

    • Note that Canon cannot be held liable for any loss or damage to the transmitter from erroneous network or FTP server settings. In addition, Canon cannot be held liable for any other loss or damage caused by use of the transmitter.
    • When using LAN functions, establish appropriate security at your own risk and discretion. Canon cannot be held liable for any loss or damage caused by unauthorized access or other security breaches.