Inserting/Removing Cards

This camera accepts two cards. Recording is possible as long as there is at least one card in the camera.

With two cards inserted, you can select one card to record to, or you can record the same image to both cards at once ().

Insertion

  1. Open the card slot cover.

    • With the card slot cover lock switch (1) slid toward the release side, pull the card slot cover toward you to open it.

  2. Insert the cards.

    Card 1

    Card 2

    • The card in the rear card slot is [Card 1], and the one in front of it is [Card 2].
    • With the card label facing you, insert the open side of the card (2) into the card slot. Inserting cards the wrong way may damage the camera.
    • The gray card-eject button pops out.

  3. Close the cover.

    • Close the cover and slide it as shown until it clicks shut.
    • After closing the cover, make sure the card slot cover lock switch is locked (3).

  4. Set the power switch to Power on ().

    (4) Card selection icon

    (5) Card 1

    (6) Card 2

    • Icons representing loaded cards are shown on the shooting screen () accessed by pressing the INFO button and on the Quick Control screen (). The camera will record to cards shown with a card selection icon [] [].

Caution

  • Only CFexpress cards can be used.

Formatting Cards

If a card is new or was previously formatted (initialized) by another camera or computer, format the card with this camera ().

Removal

  1. Open the cover.

    • Set the power switch to Power off and make sure the access lamp (7) is off.
    • With the card slot cover lock switch slid toward the release side, pull the card slot cover toward you to open it.
    • If [Saving...] is displayed on the screen, close the cover.

  2. Remove the card.

    • Press the card eject button to eject the card.
    • Pull the card straight out to remove it, then close the cover and slide the lock switch to lock it.

Caution

Do not remove cards immediately after a red [Overheating restriction (red)] icon is displayed as you are shooting. Cards may be hot, due to high internal camera temperature. Set the power switch to Power off and stop shooting for a while before removing cards. Removing hot cards immediately after shooting may cause you to drop and damage them. Be careful when removing cards.

Note

  • The number of shots available varies depending on remaining card capacity and settings such as image quality and ISO speed.
  • Setting [Shooting: Release shutter without card] to [Disable] will prevent you from forgetting to insert a card ().

Caution

  • When the access lamp is lit or blinking, it indicates that images are being written to, read from, or erased from the card, or data is being transferred. Do not open the card slot cover during this time. To avoid corrupting image data or damaging cards or the camera, never do any of the following while the access lamp is lit or blinking.

    • Removing the card.
    • Removing the battery.
    • Shaking or striking the camera.

    • Unplugging or plugging in a power cord
      (when using optional household power outlet accessories).

  • If the card already contains recorded images, the image number may not start from 0001 (, ).

  • If a card-related error message is displayed on the screen, remove and reinsert the card. If the error persists, use a different card.

    If you can transfer images on the card to a computer, transfer all the images and then format the card with the camera (). The card may then return to normal.

  • Do not touch the card's contacts with your fingers or metal objects. Do not expose the contacts to dust or water. If smudges adhere to the contacts, contact failure may result.