Wi-Fi Connection via Access Points

This section describes how to join a Wi-Fi network via an access point compatible with WPS (PBC mode).

First, check the position of the WPS button and how long to press it. It may take approx. 1 min. to establish a Wi-Fi connection.

  1. Select [Wireless settings: Wi-Fi/Bluetooth connection].

  2. Select an option.

    • If the history () is displayed, press the Left keyRight key keys to switch screens.
  3. Select [Add a device to connect to].

    • The following message is displayed if you have selected [Smartphone Connect to smartphone]. If Camera Connect is already installed, select [Do not display].
    • On the [Connect to smartphone] screen displayed next, select [Connect via Wi-Fi].
  4. Select [Switch network].

    • Displayed when [Smartphone], [Computer], or [Printer] is selected.
  5. Select [Connect with WPS].


  6. Select [WPS (PBC mode)].

    • Select [OK].
  7. Connect to the access point via Wi-Fi.

    • Press the access point's WPS button.
    • Select [OK].
  8. Select [Auto setting].

    • Select [OK] to access the setting screen for the Wi-Fi function.
    • If an error occurs with [Auto setting], see Manual IP Address Setup.
  9. Specify the settings for the Wi-Fi function.

    [ Connect to smartphone]

    • On the smartphone's Wi-Fi setting screen, tap the SSID (network name) shown on the camera, then enter the password of the access point for the connection.

    Go to step 8 in Wi-Fi Connection without Using Bluetooth.

    [ Remote control (EOS Utility)]

    Go to step 7 or 8 in Steps on the computer (2).

    [Print from Wi-Fi printer]

    Go to step 6 in Connecting to a Printer via Wi-Fi.

    Register image.canon.

    Go to step 5 in Registering image.canon.

Camera Access Point Mode

Camera access point mode is a connection mode for connecting the camera directly to each device via Wi-Fi. Displayed when [Smartphone], [Computer], or [Printer] is selected after [Wireless settings: Wi-Fi/Bluetooth connection].

Manual IP Address Setup

The options displayed vary depending on the Wi-Fi function.

  1. Select [Manual setting].

    • Select [OK].
  2. Select an option.

    • Select an option to access the screen for numerical input.
    • To use a gateway, select [Enable], then select [Address].
  3. Enter the desired values.

    • Turn the Dial dial to move the input position in the upper area, and use the Left keyRight key keys to select numbers to enter. Press the Quick Control/Set button button to enter the selected number.
    • To delete the number just entered, press the MENU button.
    • Select [OK] after the numbers have been entered. Display returns to the screen in step 2.
  4. Select [OK].

    • When you have completed setting the necessary items, select [OK].
    • If you are not sure what to enter, see Checking Network Settings, or ask the network administrator or another person knowledgeable about the network.