Specifying a Segment to Export

You can specify a segment of the video clip to export by using the control panel described below.

  • (1) Time code and duration between in/out points
  • (2) Playback position
  • (3) Move (2) to the first frame
  • (4) Back one frame
  • (5) Play/pause
  • (6) Forward one frame
  • (7) Move (2) to the last frame
  • (8) Specify the starting position (in point) for the exported clip
  • (9) Specify the ending position (out point) for the exported clip
  • (10) LUT on/off

    • Click to activate or deactivate.
    • When activated, a gamma and color gamut LUT (look-up table) suitable for the display device is applied.
  • (11) Processing resolution options

    • You can accelerate image processing by reducing the processing resolution.
  • (12) 100% display switching

    • Click to activate or deactivate.
    • When deactivated, clip display is adjusted to fit in the preview area.
    • When activated, clip display is set to 100%. For clips that exceed the preview area when displayed at 100%, a part of the clip is displayed enlarged.
    • With 100% display, you can adjust the display area by dragging the preview image. (13) shows the current position of the display area.
  • (13) Display area guide
  • (14) Mute
  • (15) Adjust the volume

    • Drag the slider to adjust the volume during playback.
  1. Move (2) to the start position.

    • To fine-tune the position, use (4) and (6).
  2. Click (8).

  3. Move (2) to the end position.

  4. Click (9).