Wireless Function Notes

If the transmission rate drops, the connection is lost, images are not displayed smoothly, or other problems occur when using the wireless functions, try the following corrective actions.

• Access Point and Antenna Installation Location

  • Install the device where people or objects do not come between it and the transmitter.
  • Install the device as close to the transmitter as possible. In particular, note that during outdoor use in poor weather, rain may absorb radio waves and disrupt the connection.

• Nearby Electronic Devices

  If the transmission rate of a wireless LAN drops because of the influence of the following electronic devices, stop using them or establish a connection farther away from them.

  • If a wireless LAN terminal on the same frequency band as the transmitter is used nearby, the transmission rate of the wireless LAN may drop.

• Access point and channel settings

  To optimize the performance of the transmitter, it is recommended that you use the transmitter under the following conditions:

  • To establish connection in infrastructure mode, it is recommended that you use channels in the 5 GHz bandwidth through an access point that is compliant with the IEEE802.11ac standards. If you use channels in the 2.4 GHz bandwidth, sufficient transmission rates may not be secured for communication.
  • To establish connection in camera access point mode, using channels in the 5 GHz bandwidth is recommended. If you use channels in the 2.4 GHz bandwidth, the performance may not be as good as expected. If the communication speed is too slow, using infrastructure mode is recommended.
  • Some of the channels are not available for wireless LAN communication depending on the laws and regulations of the area where the product is used. For details, see "Wireless LAN Restrictions" in the instructions that are provided with the product.

• Notes for Using Multiple Wireless Transmitters

  • When multiple cameras with a wireless transmitter attached are connected to one access point, make sure that the cameras' IP addresses are different.
  • When multiple cameras with a wireless transmitter attached are connected to one access point, the transmission rate drops.

  • When there are multiple IEEE 802.11n/g/b (2.4 GHz band) access points, leave a gap of four channels between each wireless LAN channel to reduce radio wave interference. For example, use channels 1, 6, and 11, channels 2, 7, and 12, or channels 3, 8, and 13.

    When IEEE 802.11ac/n/a can be used (on the 5 GHz band), switch to IEEE 802.11ac/n/a (on the 5 GHz band) and specify a different channel.