Connecting Using an Infrastructure

These instructions are continued from Displaying the Connection Wizard.

Establish a connection by selecting the SSID (or ESS-ID) of the access point to connect to.

Entering the SSID

  1. Select [Infrastructure].

    • Select [OK] to proceed to the next screen.

  2. Enter the SSID (network name).

    • Press SET to display the virtual keyboard (), then enter the SSID.
    • Select [OK] to proceed to the next screen.

Specifying the Authentication for the Access Point

  1. Select the authentication.

    • Select an item and select [OK] to go to the next screen.
    • If you select [Open system], the [Encryption settings] screen will be displayed. Select [None] or [WEP] on this screen.

Entering the Access Point Encryption Key

  • Enter the encryption key (password) specified for the access point. For details on the specified encryption key, refer to the access point's instruction manual.
  • The screens displayed in steps 4 and 5 below vary depending on the authentication and encryption specified for the access point.
  • Go to Setting the IP Address when the [IP address set.] screen is displayed instead of the screens for steps 4 and 5.

  1. Select a key index.

    • The [Key index] screen is displayed when [Shared key] and [WEP] are selected in step 3.
    • Select the key index number specified for the access point.
    • Select [OK] to proceed to the next screen.

  2. Enter the encryption key.

    • Press SET to display the virtual keyboard (), then enter the encryption key.
    • Select [OK] to establish a connection with the access point.
    • When a connection with the access point is established, the next screen is displayed.

    Go to Setting the IP Address.