Synchronizing the Time

Preparing the Sender Camera

First, configure settings on the camera that will be used as the sender.

  1. Press the MENU button on the camera.

  2. Select [Wireless settings: WFT settings].

  3. Select [Enable].

  4. Select [Sync time between cameras].

    • If another device is connected, [Set [Connection settings] to [Disconnect]] will appear. Select [OK] to terminate the connection.

  5. Select [OK].

  6. Select an option.

    • Select [OK] to proceed to the next screen.

  7. Select [Sender].

    • Select [OK] to proceed to the next screen.
    • Stay on the displayed screen.

Preparing the Receiver Cameras

Configure settings on the camera used as the receiver.

  1. Follow steps 1–6 in “Preparing the Sender Camera”.

  2. Select [Receiver].

    • Select [OK] to proceed to the next screen.

  3. Select [OK].

    • The following screen is displayed.

    • To set the time on more than one receiver camera, repeat Step 2 and 3 for all the receiver cameras.
    • The number of receiver cameras detected is displayed on the sender camera screen.

Syncing Time Between Sender and Receiver Cameras

Sync the time on the sender and receiver cameras as follows.

  1. Follow steps 1–6 in “Preparing the Sender Camera” and steps 1–3 in “Preparing Receiver Cameras.”

  2. Select [OK] on the sender camera.

    • Check the number of receiver cameras that are connected, and then select [OK].
    • The next screen is displayed once the time is synchronized.

  3. Select [OK] on all the cameras.