Autoflash with Two Receiver Groups
Receivers can be divided into firing groups A and B, and you can adjust the lighting balance (flash ratio) between them.
Exposure is automatically controlled, so that the groups' combined output provides standard exposure.
-
Press .
- Complete these settings on each receiver.
-
Set the receiver firing group in (1).
- Select either or for the firing group.
- Set one receiver to and another to .
-
Set the sender firing group in (2).
- Complete steps 3–5 on the sender.
- Turn the dial to select an option, then press .
-
Set to .
- Turn the dial to select , then press .
-
Set the A:B flash ratio.
- Press to select the option shown in the figure.
- Turn the dial to select the A:B flash ratio, then press .
-
Check the connection and make sure the flash units are charged.
- Confirm that the lamp is lit in green.
- Confirm that the sender and receiver flash-ready lamps are lit.
- Make sure is not displayed on the sender LCD panel.
- Confirm that the icon indicating completion of sender/receiver charging appears on the sender LCD panel ( is not displayed).
- For details on sender LCD panel illumination, see LCD Panel Illumination.
-
Take the picture.
- The receivers fire at the flash ratio you have set.