Synchronizing the Time

Preparing the Sender Camera

First, configure settings on the camera that will be used as the sender.

  1. Press the MENU button on the camera.

  2. Select [Connection: Network settings].

  3. Select [Enable].

  4. Select [Sync time between cameras].

    • If another device is connected, [Set [Connection settings] to [Disconnect]] will appear. Select [OK] to terminate the connection.
  5. Select [OK].

  6. Select [WFT].

    • Select [OK] to proceed to the next screen.
  7. Select [Sender].

    • Select [OK] to proceed to the next screen.
    • Stay on the displayed screen.

Preparing the Receiver Cameras

Configure settings on the camera used as the receiver.

  1. Perform Step 1 through 6 for "Preparing the Sender Camera".

  2. Select [Receiver].

    • Select [OK] to proceed to the next screen.
  3. Select [OK].

    • The following screen is displayed.

    • To set the time on more than one receiver camera, repeat Step 2 and 3 for all the receiver cameras.
    • The sender camera's monitor displays the number of receiver cameras that are detected.

Synchronizing the Time Between the Sender Camera and the Receiver Cameras

Use the menu on the sender camera and the receiver cameras to synchronize the time between them.

  1. Perform Step 1 through 6 for "Preparing the Sender Camera" and Step 1 through 3 for "Preparing the Receiver Cameras".

  2. Select [OK] on the sender camera.

    • Check the number of receiver cameras that are connected, and then select [OK].
    • The next screen is displayed once the time is synchronized.
  3. Select [OK] on all the cameras.