Inserting/Removing Batteries

Insert a fully charged Battery Pack LP-E19 into the camera.

Insertion

  1. Remove the battery compartment cap.

  2. Insert the battery.

    • Insert the battery firmly, all the way in, then turn the battery release handle as shown by the arrow.

Caution

  • There may be a slight delay before the camera turns on when a battery is used in the camera for the first time.
  • You cannot use batteries other than Battery Pack LP-E19.

Note

  • Wipe away any dirt on the battery's water-repellent rubber lining (1) with a moistened cotton swab.

Removal

  1. Turn the battery release handle and remove the battery.

    • Make sure the power switch is set to Power off ().
    • Flip out the battery release handle, turn it as shown by the arrow, and remove the battery.
    • To prevent short-circuits, always attach the included protective cover () to the battery.
    • When not using the camera, attach the battery compartment cap ().

Caution

Do not remove the battery immediately after a red [Overheating restriction (red)] icon is displayed as you are shooting. The battery may be hot, due to high internal camera temperature. Before removal, set the power switch to Power off and stop shooting for a while. Removing a hot battery immediately after shooting may cause you to drop and damage it. Be careful when removing the battery.