Erasing Images

You can either select and erase unnecessary images individually or erase them in one batch. Protected images () will not be erased.

Caution

Once an image is erased, it cannot be recovered. Make sure you no longer need the image before erasing it. To prevent important images from being erased accidentally, protect them.

Erasing Images Individually

Note

By adding checkmarks to the images to be erased, you can erase all those images at once.

Select [: Erase images].
Select [Select and erase images].
Select an image.
- Turn the dial to select an image to erase, then press .
- To select another image to be erased, repeat step 3.
Erase the images.
- Press the button, then press [OK].

While looking at the images in the index display, you can specify the first and last images for a range to erase all the specified images at once.

Select [Select range].
- Select [Select range] in [: Erase images].
Specify the range of images.
- Select the first image (start point).
- Next, select the last image (end point). A checkmark [] will be appended to all the images within the range between first and last images.
- To select another image to be erased, repeat step 2.
Press the button.
Erase the images.
- Select [OK].

You can erase all the images in a folder or on a card at once.

When you select [All images in folder] or [All images on card] in [: Erase images], all the images in the folder or on the card will be erased.
If the search conditions are set with [: Set image search conditions] (), the display will change to [All found images].

If you select [All found images], all the images filtered by the search conditions will be erased.

Note

To erase all the images including protected images, format the card ().
Erasing images by selecting [All images on card] applies to the card selected in [: Record func+card/folder sel.] (in either [ Record/play]/[ Record/play] or [ Play]/[ Play]).