Remote Release from a Receiver Unit
When using an EOS DIGITAL camera released in or after 2012, you can perform remote release (remote control shooting) from an EL-1 set as a receiver unit during radio transmission wireless shooting.
Push the joystick vertically.
Take the picture.
- Press the joystick up, down, left, or right, or turn and select , then press the joystick vertically.
- A release signal is sent from the receiver unit to the sender unit, and the picture is taken.
- Remote release is not possible from a receiver unit in cameras released up to 2011 or EOS REBEL T100/4000D/3000D, EOS REBEL T7/1500D/2000D, EOS REBEL T6/1300D or EOS REBEL T5/1200D.
- Shooting is not possible when autofocus fails. It is recommended that you set the focus mode switch of the lens to , manually focus on the subject, then release.