Using the Viewfinder

Look through the viewfinder to activate it. You can also restrict display to either the screen or viewfinder ().

Dioptric Adjustment

Adjust the diopter for clear viewfinder display.

  • Pull out the dioptric adjustment dial to unlock it, then turn the dial right or left.
  • When finished, push the dial in to lock it.

Caution

  • The viewfinder and screen cannot be activated at the same time.
  • At some aspect ratios, black bars are displayed on the top and bottom or left and right edges of the screen. These areas are not recorded.

Replacing Eyecup ER-i

Follow these steps if you need to replace Eyecup ER-i.

  1. Detach the eyecup.

    • Eyecup lock levers (1) are on both sides of the eyecup.
    • Press in the levers as you lift the eyecup straight up.

  2. Attach a new eyecup.

Using Eyecup ER-iE (Sold Separately)

Outdoors, using Eyecup ER-iE may improve eye control accuracy and viewfinder visibility.

  1. Detach the eyecup.

    • Eyecup lock levers (1) are on both sides of the eyecup.
    • Press in the levers as you lift the eyecup straight up.

  2. Attach Eyecup ER-iE.

    • Hold Eyecup ER-iE as shown.
    • With the side grooves of Eyecup ER-iE aligned with the camera, slide the eyecup down until it stops.
    • You can rotate Eyecup ER-iE as necessary for adjustment. It clicks every 90° and can be rotated 360°.

  3. To remove Eyecup ER-iE:

    • Holding Eyecup ER-iE as shown, pull it straight up.
    • Note that the rubber part may come off if pulled too forcefully.