Headphones

Volume

  1. Select [Set-up: Headphones] ().

  2. Select [Volume].

  3. Adjust the volume.

    • Turn the Control dial dial to adjust the volume, then press Quick Control/Set.

Note

  • You can check sound from the built-in microphone or an external microphone on headphones when [Shooting: Sound recording] is set to an option other than [Disable] and [Shooting: High Frame Rate] is set to [Off].

Monitor CH

  1. Select [Monitor CH].

  2. Select the combination of channels for audio output (L/R).

    • [CH1+2] indicates that the signal is a combination of channels 1 and 2.

Audio Monitor

You can choose the audio during movie recording that is used for headphone output. To reduce noise in audio recording, configure [Audio noise reduc.] ().

  1. Select [Audio monitoring].

  2. Select an option.

    • Real-time audio (without NR)

      Audio output without noise reduction.

    • Recorded audio (NR applied)

      Audio output with noise reduction.

Caution

  • Selecting [Recorded audio (NR applied)] results in audio output that is slightly out of sync with video. Audio in recorded movies is not delayed.