Editing a Movie's First and Last Scenes

You can edit out the first and last scenes of a movie in approx. 1-sec. increments.

In single-image display, press .
On the movie playback panel, select [].
Specify the part to be edited out.
- Select either [] (Cut beginning) or [] (Cut end).
- Press left or right to go back or forward one frame. Keep pressing the Multi-controller to fast rewind or fast forward frames. Each turn of the dial goes back or forward one frame.
- After deciding which part to edit out, press . The portion indicated by a line at the bottom of the screen will remain.
Check the edited movie.
- Select [] to play back the edited movie.
- To change the edited part, go back to step 3.
- To cancel the editing, press the button.
Save.
- Select [] (1).
- The save screen will appear.
- To save it as a new file, select [New file], or to save it and overwrite the original movie file, select [Overwrite].
  Select [] (2) to save a compressed version of the file. 4K movies are converted to Full HD movies before compression.
- On the confirmation screen, select [OK] to save the edited movie and return to the movie playback screen.

Caution

Because editing is performed in approx. 1 sec. increments (at the position indicated by [] at the bottom of the screen), the actual position where movies are trimmed may differ from your specified position.
Movies shot with another camera cannot be edited with this camera.
You cannot edit a movie when the camera is connected to a computer.
Compress and save is not available for the following movies.
- Movies recorded with [: HDR shooting ] set to [Enable]
- Movies recorded with [: Canon Log settings] set to [On ()]
- Movies recorded in (NTSC), (PAL), (NTSC), or sizes
Movies may not be compressed when the remaining batter capacity is low. Use of a fully charged battery or a household power outlet accessory (sold separately) is recommended.
For extensive movie editing, consider using an optional household power outlet accessory.