Auto Exposure Bracketing (AEB)

In exposure bracketing, three consecutive images are captured at different exposures within your specified range of up to ±3 stops (in 1/3-stop increments) by automatically adjusting the shutter speed, aperture value, or ISO speed.

AEB stands for Auto Exposure Bracketing.

Setting with camera controls

  1. Press the Drive mode/AF operation selection and Flash exposure compensation/metering mode selection button at the same time.

  2. Set the AEB range.

    • Turn the Main dial, Quick control dial 1, or Quick control dial 2 dial to set the AEB range.
    • The AEB range is displayed on the shooting screen when you return to that screen.
  3. Take the picture.

    Standard exposure

    Decreased exposure

    Increased exposure

    • Three bracketed shots are taken, according to the specified drive mode, in this sequence: Standard exposure, decreased exposure, and increased exposure.
    • AEB will not be automatically canceled. To cancel AEB, follow step 2 to set the AEB range to “0.”

Setting from the menu

  1. Select [Shooting: Expo.comp./AEB].

  2. Set the AEB range.

    • Turn the Main dial dial to set the AEB range (1). By turning the Quick control dial 1 dial, you can set the exposure compensation amount.
    • Press SET to set it.
    • When you close the menu, the AEB range will be displayed on the screen.
  3. Take the picture.

    • Shoot as described in step 3 of Setting with camera controls.
    • AEB will not be automatically canceled. To cancel AEB, follow step 2 to turn off the AEB range display.

Caution

  • Exposure compensation in AEB may be less effective with [Shooting: Auto Lighting Optimizer] () set to an option other than [Disable].

Note

  • [AE lock] blinks in the lower left of the screen during AEB.
  • If the drive mode is set to [Single shooting], press the shutter button three times for each shot. In [High-speed continuous shooting plus], [High-speed continuous shooting], or [Low-speed continuous shooting] mode, holding down the shutter button completely captures three images, one after another, before the camera automatically stops shooting. When [10 sec. self-timer] or [2 sec. self-timer] is set, three consecutive shots are captured after a delay of 10 or 2 sec.
  • You can set AEB in combination with exposure compensation.
  • AEB is not available in flash photography or bulb exposures, or when set to Multi Shot Noise Reduction, HDR mode, or focus bracketing.
  • AEB will be canceled automatically if you do any of the following: Setting the power switch to Power off or when the flash is fully charged.