Touch & Drag AF Settings
You can move the AF point or Zone AF frame by tapping or dragging on the screen as you look through the viewfinder.
Touch & Drag AF
Select [: Touch & drag AF settings].
Select [Touch & drag AF].
- Select [Enable].
Tapping to Select Subjects for
To switch the subject tracked to a different person when several faces are detected with the AF method set to , you can tap the area set in [Active touch area].
Note that this setting is not available with [Touch & drag AF] set to [Enable].
Select [Tap to select subject for ].
- To switch to a person on the left, tap the left side of the area set in [Active touch area], and to switch to a person on the right, tap the right side.
- With [Eye detection] set to [Enable], the camera switches to the eyes of a different subject.
You can set how positions are specified by tapping or dragging.
Set [Positioning method].
The AF point moves to the tapped or dragged position on the screen.
The AF point moves in the direction you drag, as much as you drag, no matter where you touch the screen.
Active Touch Area
You can specify the area of the screen used for tap and drag operations.
Select [Active touch area].
Set the area that will respond to touch.
- Tapping the screen with [+Tracking] set displays a round orange frame . After you lift your finger at the position to move the AF point to,  is displayed and that subject is tracked. To cancel subject selection, hold down the button.