Touch & Drag AF Settings
You can move the AF point or Zone AF frame by tapping or dragging on the screen as you look through the viewfinder.
Touch & Drag AF
Select [: Touch & drag AF settings].
Select [Touch & drag AF].
- Select [Enable].
You can set how positions are specified by tapping or dragging.
Set [Positioning method].
The AF point moves to the tapped or dragged position on the screen.
The AF point moves in the direction you drag, by an amount corresponding to the amount you drag, no matter where you tap the screen.
Active Touch Area
You can specify the area of the screen used for tap and drag operations.
Select [Active touch area].
Set the area that will respond to touch.
- A round orange frame  is displayed when you tap the screen with [: AF area] set to [Whole area AF]. After you lift your finger at the position to move the AF point to,  is displayed and that subject is tracked. To cancel subject selection, tap .