Transferring Images Individually

Automatic Image Transfer After Each Shot

An image can be automatically transferred to the FTP server immediately after shooting. You can also continue still photo shooting even while images are being transferred.

  • Before shooting, be sure to insert a card into the camera. If you shoot without recording images, they cannot be transferred.
  • Note that automatic transfer of movies during shooting is not supported. Transfer the images after shooting, referring to Batch Transfer or Transferring Images with a Caption.
  1. Select [Connection: Network settings].

  2. Select [Connection option settings].

  3. Select [FTP transfer settings].

  4. Select [Automatic transfer].

  5. Select [Enable].

  6. Take the picture.

    • The captured image is transferred to the FTP server.

Caution

  • Images cannot be erased during image transfer.
  • No voice memo can be added when [Automatic transfer] is set to [Enable].

Note

  • During continuous shooting, images are transferred to the FTP server in the order they are captured.
  • The captured images are also stored on the card.
  • Any images for which transfer is interrupted or fails will be transferred automatically when the connection is recovered (). These images can also be re-transferred in batch at a later time ().
  • If network settings such as the connected FTP server are changed before FTP auto retry starts, FTP auto retry will not occur.

Transferring the Current Image

Simply play back images and press SET to transfer them. You can also continue still photo shooting even while images are being transferred.

  1. Display the [FTP transfer settings] screen.

  2. Select [Transfer with SET].

  3. Select [Enable].

  4. Select an image.

    • Press the Playback button on the camera.
    • Select the image to transfer, then press SET to transfer the image.
    • A voice memo can be added to the played back image before it is transferred. For details, refer to the EOS-1D X Mark III Instruction Manual.
    • Movies cannot be transferred this way. Selecting a movie and pressing SET will display the movie playback panel.

Selecting the Size and Type of Images to Transfer

You can configure settings for when images with different sizes have been recorded on the CFexpress card at the same time, or specify how to transfer images shot in the RAW+JPEG or RAW+HEIF format.

  1. Display the [FTP transfer settings] screen.

  2. Select [Transfer type/size].

  3. Select the size of the images to transfer.

    • Select [JPEG size to trans.], then select either [Larger JPEG] or [SmallerJPEG].

    • If you want to transfer JPEG small images when images are specified to be recorded as JPEG large on one CFexpress card and JPEG small on another card, specify [JPEG size to trans.: SmallerJPEG].
  4. Select the type of images to transfer.

    • RAW+JPEG transfer

      • Select [RAW+JPEG transfer], then select [JPEG only], [RAW only], or [RAW+JPEG].
    • RAW+HEIF transfer

      • Select [RAW+HEIF transfer], then select [HEIF only], [RAW only], or [RAW+HEIF].

Note

  • If images are specified to be recorded as RAW on one CFexpress card and JPEG or HEIF on another card, determine the image to be transferred by using the [RAW+JPEG transfer] or [RAW+HEIF transfer] setting. Also use this setting when RAW+JPEG or RAW+HEIF images are simultaneously recorded on a single card.
  • The captured images are also stored on the card.
  • If images of the same size are simultaneously recorded on two cards, the images recorded on the card that is preferentially specified in [Shooting Record/play] or [Shooting Play] under [Function settings: Record func+card/folder sel.] will be transferred.