Connecting to a Detected Network Manually

These instructions are continued from Checking the Type of Access Point.

Establish a connection by selecting the SSID (or ESS-ID) of the access point to connect to from a list of active access points nearby.

Selecting an Access Point

  1. Select an Access Point.

    • (1) SSID
    • (2) An icon is displayed if the access point is encrypted
    • (3) Channel used
    • Using Quick Control Dial, select the access point to connect to from the list of access points.

Note

  • [Refresh]

  • Scroll down the screen in step 1 to display [Refresh].
  • Select [Refresh] to search for access points again.

Entering the Access Point Encryption Key

  • Enter the encryption key (password) specified for the access point. For details on the specified encryption key, refer to the access point's instruction manual.
  • The screens displayed in steps 2 and 3 below vary depending on the authentication and encryption specified for the access point.
  • Go to Setting the IP Address when the [IP address set.] screen is displayed instead of the screens for steps 2 and 3.

  1. Select a key index.

    • The [Key index] screen is displayed only if the access point uses WEP encryption.
    • Select the key index number specified for the access point.
    • Select [OK] to proceed to the next screen.

  2. Enter the encryption key.

    • Press SET to display the virtual keyboard (), then enter the encryption key.
    • Select [OK] to establish a connection with the access point.
    • When a connection with the access point is established, the next screen is displayed.

    Go to Setting the IP Address.